All Sport MX-1: What does the LED status mean?

Topic

  • What does the LED status light on the All Sport MX-1 mean?

  • What diagnostics are on the All Sport MX-1?

Environment

  • Product: All Sport MX-1
  • Components: LED Status light
  • Control System: Scoreboard with Dak Score control

Steps

When the All Sport MX-1 is powered on, it will run through a power on self-test (POST) to test its hardware functionality. If an error is found, the error will be reported via the status LED.

Normal Operation

  • LED will flash with an On/Off heartbeat when running and not connected to a Bluetooth® device.
  • LED will be steady ON when connected to a Bluetooth® device.

Error Condition Status reported

  • The LED will indicate any error condition by turning on steady for 3 seconds and then follow that with a specific number of "LED flash to ON" for the # of the error state being reported.  The MX-1 will continue to go through this pattern until it is reset or power cycled.  It will flash the # of the most severe error condition if more than 1 is present.  A list of the possible error conditions is shown here in order of severity:
# of FlashesError Description Possible Symptoms User May See
13.3 Volt High Error The Bluetooth® module and scoreboard radio may not work and the power LED may not be on.
2Bluetooth® Connection Error The user may not be able to communicate with the MX-1 via Bluetooth® communication.
3Input Voltage Low Error Wired scoreboard communications may not work.
4Input Voltage High Error Wired scoreboard communications may not work.
5Scoreboard Radio Error Scoreboard radio communications may not work.
6Super Cap Error The MX-1 may not be able to save game-in-progress data through a power cycle.
7SPI Flash Memory Error Over-the-air updates to the MX-1 may not work.
8Current Loop Low Error Wired scoreboard communications may not work.
9Current Loop High Error Wired scoreboard communications may not work.
103.3 Volt Low Error May not be able to save game-in-progress data through an MX-1 power cycle. The power LED may be stuck on.


KB ID: DD3881924


DISCLAIMER: Use of this content may void the equipment warranty, please read the disclaimer prior to performing any service of the equipment.

DAKTRONICS DOES NOT PROMISE THAT THE CONTENT PROVIDED HEREIN IS ERROR-FREE OR THAT ANY DEFECTS WILL BE CORRECTED, OR THAT YOUR USE OF THE CONTENT WILL PROVIDE SPECIFIC RESULTS. THE CONTENT IS DELIVERED ON AN "AS-IS" AND "AS-AVAILABLE" BASIS. ALL INFORMATION PROVIDED IN THIS ARTICLE IS SUBJECT TO CHANGE WITHOUT NOTICE. DAKTRONICS DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ANY WARRANTIES OF ACCURACY, NON-INFRINGEMENT, MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. DAKTRONICS DISCLAIMS ANY AND ALL LIABILITY FOR THE ACTS, OMISSIONS AND CONDUCT OF YOU OR ANY THIRD PARTIES IN CONNECTION WITH OR RELATED TO YOUR USE OF THE CONTENT. ADJUSTMENT, REPAIR, OR SERVICE OF THE EQUIPMENT BY ANYONE OTHER THAN DAKTRONICS OR ITS AUTHORIZED REPAIR AGENTS MAY VOID THE EQUIPMENT WARRANTY. YOU ASSUME TOTAL RESPONSIBILITY FOR YOUR USE OF THE CONTENT AND ANY LINKED CONTENT. YOUR SOLE REMEDY AGAINST DAKTRONICS FOR DISSATISFACTION WITH THE CONTENT IS TO STOP USING THE CONTENT. THIS LIMITATION OF RELIEF IS A PART OF THE BARGAIN BETWEEN THE PARTIES.

The above disclaimer applies to any property damage, equipment failure, liability, infringement, or personal injury claim arising out of or in any way related to your use or application of the content, whether such claim is for breach of contract, tort, negligence or any other cause of action.