How to test an All Sport CG Serial TV Feed

Question

  •  How do I test the All Sport CG Serial TV Feed output​​?

Environment

  • Product Family: Sports Product, Control System
  • Product:
  • Component:
  • Control System: All Sport CG SD Hardware Rev 1 or 2 with ED-15106 version 2.0 or greater, All Sport CG SD Hardware Rev 3 with ED-3057466 version 1.0 or greater, All Sport CG HD Hardware Rev 1 with ED-2931415 version 1.0 or greater, All Sport 5500, 5000, 3000 using MDP code ONLY

Answers/Steps

  1. If using older All Sport CG Hardware Rev 1 or 2 ensure it has version 2.0 or higher firmware installed.
  2. The test for the TV Feed output perform the following:
    1. Connect a straight-through 9-pin serial cable from the CONTROL jack on top of the All Sport CG to a Laptop(computer). 
    2. Using Hyper-Term or Tera-Term setup the computer comm port for bps: 9,600, Data bits:8, Parity:N, Stop bits:1, Flow: N. 
    3. Start the All Sport counting down and see the clock data in hyper-term.

Additional Information

KB ID: DD2194984


Fill out my online form.
DISCLAIMER: Use of this content may void the equipment warranty, please read this DISCLAIMER prior to performing any service of the equipment.