FL-3000/FL-4500 Unable to change prices on multiple displays using DM-100, Reset system
Potential Symptoms
- Unable to change prices on all displays
- Can change displays from external access port J-Box.
- May only change the primary side until power cycled.
- Price doesn't change and DM-100 LED screen stays stagnant and never connects to display.
- Error appears on the DM-100 when updating displays
Environment
- Product: FL-3000, FL-4500
- Components: FLR3-1500, FLR3-2000, FLXR3, FLXR4
- Control System: DM-100
Cause
- DM-100 failed to initialize all displays.
Resolution
- Perform the following boot up sequence to the system.if using serial radios
- Power down all pylons and server radio j-box.
- Disconnect DM-100 from radio j-box. (Left serial cable connection on top of DM-100)
- Power up server radio j-box. Wait 30 seconds.
- Power up all pylons one at a time. Wait 30 seconds after each.
- Plug DM-100 into radio J-box and verify each network is found.
- Detect displays from Diagnostics Menu of DM-100 (if needed).
- Within the DM-100 go to Diagnostics Menu and select Detect Displays.
- Refer to: Digit and Price Displays: How do I run the Detect Displays function on a DM-100?
- If using FLXR radios then refer to this article: FLXR: How to properly power cycle digit gas price displays that are controlled by FLXR radios.
KB ID: DD3019586
DISCLAIMER: Use of this content may void the equipment warranty, please read the disclaimer prior to performing any service of the equipment.
DAKTRONICS DOES NOT PROMISE THAT THE CONTENT PROVIDED HEREIN IS ERROR-FREE OR THAT ANY DEFECTS WILL BE CORRECTED, OR THAT YOUR USE OF THE CONTENT WILL PROVIDE SPECIFIC RESULTS. THE CONTENT IS DELIVERED ON AN "AS-IS" AND "AS-AVAILABLE" BASIS. ALL INFORMATION PROVIDED IN THIS ARTICLE IS SUBJECT TO CHANGE WITHOUT NOTICE. DAKTRONICS DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ANY WARRANTIES OF ACCURACY, NON-INFRINGEMENT, MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. DAKTRONICS DISCLAIMS ANY AND ALL LIABILITY FOR THE ACTS, OMISSIONS AND CONDUCT OF YOU OR ANY THIRD PARTIES IN CONNECTION WITH OR RELATED TO YOUR USE OF THE CONTENT. ADJUSTMENT, REPAIR, OR SERVICE OF THE EQUIPMENT BY ANYONE OTHER THAN DAKTRONICS OR ITS AUTHORIZED REPAIR AGENTS MAY VOID THE EQUIPMENT WARRANTY. YOU ASSUME TOTAL RESPONSIBILITY FOR YOUR USE OF THE CONTENT AND ANY LINKED CONTENT. YOUR SOLE REMEDY AGAINST DAKTRONICS FOR DISSATISFACTION WITH THE CONTENT IS TO STOP USING THE CONTENT. THIS LIMITATION OF RELIEF IS A PART OF THE BARGAIN BETWEEN THE PARTIES.
The above disclaimer applies to any property damage, equipment failure, liability, infringement, or personal injury claim arising out of or in any way related to your use or application of the content, whether such claim is for breach of contract, tort, negligence or any other cause of action.