How to setup OmniSport 2000 Swimming RTD to push to a DMP-8000 controlled display serially through DCS.

Topic

How do you send Swimming RTD to a DMP-8000 or Galaxy controlled display when connecting the OmniSport 2000 RTD port serially to DCS?

Environment

  • OmniSport 2000
  • SCS w/ DCS
  • DMP-8000
  • M3 Controlled Galaxy
  • Hy-Tek Meet Manager for Swimming
  • OmniSport Pro Swimming

Steps

  1. Connect equipment as shown below:
    Omni connections.jpg
  2. Setup DCS Ports: Omni 2000 RTD from RTD on Omni to usb serial.
  3. Output is 21000 or 3002 depending on controller
  4. DCS.jpg
  5. Setup DCS Data View, so RTD Data on Port 1 is connecting to TX on Port 2:
    DCS Data Flow.jpg
  6. From the DMP-8000 computer, verify that the OS2-Swimming.dsrc file is configured correctly:
    For location of DSCR files, please see Common Common VNET ( DMP-8000 ) file locations, DD2565688.
    OS2 dsrc.jpg
     
  7. Create a message in Content Studio using Swim Timer A.
    • May need to verify that Swim Timer A is using OS2-Swimming.did with Profile Editor.
    • Contact the Daktronics Help Desk if unsure how to use Profile Editor.
  8. Configure OmniSport Pro Swimming for pool configuration, and setup correct COM Port values for the connection to the OmniSport 2000 Expansion Port.
  9. Configure Hy-Tek MM timing console and close the COM Port to the OmniSport 2000 Results port. 
  10. Download events into the OmniSport 2000 (DAKT2) from Hy-Tek MM, and confirm that you can pull open the meets on Pro Swimming, and start a meet.

KB ID: DD2633251


DISCLAIMER: Use of this content may void the equipment warranty, please read the disclaimer prior to performing any service of the equipment.

DAKTRONICS DOES NOT PROMISE THAT THE CONTENT PROVIDED HEREIN IS ERROR-FREE OR THAT ANY DEFECTS WILL BE CORRECTED, OR THAT YOUR USE OF THE CONTENT WILL PROVIDE SPECIFIC RESULTS. THE CONTENT IS DELIVERED ON AN "AS-IS" AND "AS-AVAILABLE" BASIS. ALL INFORMATION PROVIDED IN THIS ARTICLE IS SUBJECT TO CHANGE WITHOUT NOTICE. DAKTRONICS DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ANY WARRANTIES OF ACCURACY, NON-INFRINGEMENT, MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. DAKTRONICS DISCLAIMS ANY AND ALL LIABILITY FOR THE ACTS, OMISSIONS AND CONDUCT OF YOU OR ANY THIRD PARTIES IN CONNECTION WITH OR RELATED TO YOUR USE OF THE CONTENT. ADJUSTMENT, REPAIR, OR SERVICE OF THE EQUIPMENT BY ANYONE OTHER THAN DAKTRONICS OR ITS AUTHORIZED REPAIR AGENTS MAY VOID THE EQUIPMENT WARRANTY. YOU ASSUME TOTAL RESPONSIBILITY FOR YOUR USE OF THE CONTENT AND ANY LINKED CONTENT. YOUR SOLE REMEDY AGAINST DAKTRONICS FOR DISSATISFACTION WITH THE CONTENT IS TO STOP USING THE CONTENT. THIS LIMITATION OF RELIEF IS A PART OF THE BARGAIN BETWEEN THE PARTIES.

The above disclaimer applies to any property damage, equipment failure, liability, infringement, or personal injury claim arising out of or in any way related to your use or application of the content, whether such claim is for breach of contract, tort, negligence or any other cause of action.