Daktronics

Unable to connect to message center display with Ethernet communication, Incorrect port.

Potential Symptoms

  • Default port 3001 in M2Config and Venus V4 is selected but the port is not using 3001.

Environment

  • Product Family: Message Displays, Software
  • Product:
  • Component: Ethernet based communication (Ethernet Bridge Radio (EBR), Fiber Ethernet, Copper Ethernet)
  • Control System: Venus 1500 V3, Venus 1500 V4, M2Config

Cause

  • Default port 3001 in M2Config and Venus V4 is selected but the port is not using 3001.

Resolution

  • Verify which port Venus and M2Config should be set to.

    • Uncheck Use Default (3001) and enter the correct port number in Venus V4 under Configure Display, Ethernet Connection, Enter a DNS or IP address below and specify a port number.
    • Click continue and finish configuring the display in V4, verify communication.
    • M2Config: Select Connection Configuration, uncheck Use Default (3001) and enter the correct port number (Socket) and click ok. Verify communication to the display in M2Config.

KB ID: DD4236944

DISCLAIMER: Use of this content may void the equipment warranty, please read the disclaimer prior to performing any service of the equipment.

DAKTRONICS DOES NOT PROMISE THAT THE CONTENT PROVIDED HEREIN IS ERROR-FREE OR THAT ANY DEFECTS WILL BE CORRECTED, OR THAT YOUR USE OF THE CONTENT WILL PROVIDE SPECIFIC RESULTS. THE CONTENT IS DELIVERED ON AN "AS-IS" AND "AS-AVAILABLE" BASIS. ALL INFORMATION PROVIDED IN THIS ARTICLE IS SUBJECT TO CHANGE WITHOUT NOTICE. DAKTRONICS DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ANY WARRANTIES OF ACCURACY, NON-INFRINGEMENT, MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. DAKTRONICS DISCLAIMS ANY AND ALL LIABILITY FOR THE ACTS, OMISSIONS AND CONDUCT OF YOU OR ANY THIRD PARTIES IN CONNECTION WITH OR RELATED TO YOUR USE OF THE CONTENT. ADJUSTMENT, REPAIR, OR SERVICE OF THE EQUIPMENT BY ANYONE OTHER THAN DAKTRONICS OR ITS AUTHORIZED REPAIR AGENTS MAY VOID THE EQUIPMENT WARRANTY. YOU ASSUME TOTAL RESPONSIBILITY FOR YOUR USE OF THE CONTENT AND ANY LINKED CONTENT. YOUR SOLE REMEDY AGAINST DAKTRONICS FOR DISSATISFACTION WITH THE CONTENT IS TO STOP USING THE CONTENT. THIS LIMITATION OF RELIEF IS A PART OF THE BARGAIN BETWEEN THE PARTIES.

The above disclaimer applies to any property damage, equipment failure, liability, infringement, or personal injury claim arising out of or in any way related to your use or application of the content, whether such claim is for breach of contract, tort, negligence or any other cause of action.