Temperature Alert on MLC in IDM, Fan malfunction

Potential Symptoms

  • Max temperature¬†alert on MLC in IDM.
  • Fuse is blown on power supply.
  • Fan/s not working.

Environment

  • Product Family: Billboard
  • Product: DB-3000
  • Component: Fan
  • Control System:

Cause

  • Fan malfunction.

Resolution

  1. Disconnect harness for fans going to power supply.
  2. Replace fuse at power supply.
  3. Disconnect one of the fans from harness.
  4. Connect the harness back to power supply. If the fuse blows out, disconnect harness again and reconnect the fans. Repeat steps 1-3 to isolate potential bad fan or fans.
  5. If the fuse does not blow out while one is not connected than replace disconnected fan.

If you go through each fan and the fuse continues to blow out, check harness for damage and replace it.

For Temporary Operation

  • Leave single fan disconnected, if applicable, until parts arrive to replace fan.

KB ID: DD3860020


DISCLAIMER: Use of this content may void the equipment warranty, please read the disclaimer prior to performing any service of the equipment.

DAKTRONICS DOES NOT PROMISE THAT THE CONTENT PROVIDED HEREIN IS ERROR-FREE OR THAT ANY DEFECTS WILL BE CORRECTED, OR THAT YOUR USE OF THE CONTENT WILL PROVIDE SPECIFIC RESULTS. THE CONTENT IS DELIVERED ON AN "AS-IS" AND "AS-AVAILABLE" BASIS. ALL INFORMATION PROVIDED IN THIS ARTICLE IS SUBJECT TO CHANGE WITHOUT NOTICE. DAKTRONICS DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ANY WARRANTIES OF ACCURACY, NON-INFRINGEMENT, MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. DAKTRONICS DISCLAIMS ANY AND ALL LIABILITY FOR THE ACTS, OMISSIONS AND CONDUCT OF YOU OR ANY THIRD PARTIES IN CONNECTION WITH OR RELATED TO YOUR USE OF THE CONTENT. ADJUSTMENT, REPAIR, OR SERVICE OF THE EQUIPMENT BY ANYONE OTHER THAN DAKTRONICS OR ITS AUTHORIZED REPAIR AGENTS MAY VOID THE EQUIPMENT WARRANTY. YOU ASSUME TOTAL RESPONSIBILITY FOR YOUR USE OF THE CONTENT AND ANY LINKED CONTENT. YOUR SOLE REMEDY AGAINST DAKTRONICS FOR DISSATISFACTION WITH THE CONTENT IS TO STOP USING THE CONTENT. THIS LIMITATION OF RELIEF IS A PART OF THE BARGAIN BETWEEN THE PARTIES.

The above disclaimer applies to any property damage, equipment failure, liability, infringement, or personal injury claim arising out of or in any way related to your use or application of the content, whether such claim is for breach of contract, tort, negligence or any other cause of action.