Daktronics

Replacing Logic Card in Data Display Sign

Topic

  • What is needed to be done to swap out a bad Logic 2001 or 2000 in a Data Display Box-Office, Lobby or Auditorium Sign.

Environment

  • Product: DAK Ireland/ Data Display Legacy
  • Component: Logic 2001
  • Control System: DVS

Steps

  1. First step when Logic card arrives on site is to open the sign and locate the bad logic card being swapped out.
  2. Before taking out original logic card make sure you match all Dip Switches and jumpers on the new card being installed.
  3. Once everything matches you can disconnect the power to the logic card.
  4. Next disconnect the ribbon cable and the data wires going into the terminal block on the bottom right hand side of the logic card.
  5. Unscrew the 4 nuts holding the Logic in place and pop the logic card out and install the new one.
  6. Once new Logic is secured in the sign you can begin to hook up the Ribbon Cable and Data Wiring.
  7. Once everything is hooked up you can put the power to the logic card.
    1. On power up some times these logics hold memory from testing so you may need to run a Power Up Sequence in software to refresh the sign and push the information.
    2. To do this open CinSDS32. Go to Configuration-Setup-Power Up Sequence at the very bottom.
    3. Click okay and you will see the icon in software go from yellow to blue back to yellow. Once yellow again the message has successfully been sent to the sign.

KB ID: DD3501129

DISCLAIMER: Use of this content may void the equipment warranty, please read the disclaimer prior to performing any service of the equipment.

DAKTRONICS DOES NOT PROMISE THAT THE CONTENT PROVIDED HEREIN IS ERROR-FREE OR THAT ANY DEFECTS WILL BE CORRECTED, OR THAT YOUR USE OF THE CONTENT WILL PROVIDE SPECIFIC RESULTS. THE CONTENT IS DELIVERED ON AN "AS-IS" AND "AS-AVAILABLE" BASIS. ALL INFORMATION PROVIDED IN THIS ARTICLE IS SUBJECT TO CHANGE WITHOUT NOTICE. DAKTRONICS DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ANY WARRANTIES OF ACCURACY, NON-INFRINGEMENT, MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. DAKTRONICS DISCLAIMS ANY AND ALL LIABILITY FOR THE ACTS, OMISSIONS AND CONDUCT OF YOU OR ANY THIRD PARTIES IN CONNECTION WITH OR RELATED TO YOUR USE OF THE CONTENT. ADJUSTMENT, REPAIR, OR SERVICE OF THE EQUIPMENT BY ANYONE OTHER THAN DAKTRONICS OR ITS AUTHORIZED REPAIR AGENTS MAY VOID THE EQUIPMENT WARRANTY. YOU ASSUME TOTAL RESPONSIBILITY FOR YOUR USE OF THE CONTENT AND ANY LINKED CONTENT. YOUR SOLE REMEDY AGAINST DAKTRONICS FOR DISSATISFACTION WITH THE CONTENT IS TO STOP USING THE CONTENT. THIS LIMITATION OF RELIEF IS A PART OF THE BARGAIN BETWEEN THE PARTIES.

The above disclaimer applies to any property damage, equipment failure, liability, infringement, or personal injury claim arising out of or in any way related to your use or application of the content, whether such claim is for breach of contract, tort, negligence or any other cause of action.