Daktronics

How do I set up an OmniSport 2000 for DiveMeets?

Topic

  • How do I set up an OmniSport 2000 for DiveMeets?

Environment

  • OmniSport 2000
  • DiveMeets aka DiveMeets.com

Steps

See http://www.divemeets.com/instant_demo/dak/dak_setup.html for any updates to below info.

  1. Install the Serial to USB driver on your computer (comes with your cable)
  2. Plug the Serial to USB cable into the "Expansion Port" on the OmniSport
  3. Plug the other end of the Serial cable into a USB port in your computer.
  4. Turn the OmniSport 2000 power switch to "On"
  5. From the Date window press " Enter "
  6. From the Time window press "Enter "
  7. From the Swimming window press "Next"
  8. From the Diving Window press "Enter" 
Your Omni Sport is now ready to run DiveMeets. There is nothing else you nee to do on the OmniSport.

How to setup a DiveMeets Computer for the OmniSport

  1. From your Desktop click the Icon that says "Meet Control"
  2. The meet name should be in the first screen, if it is not; you need to download your meet"
  3. Place a check next to the meet name.
  4. Click " Work With Meet Selected"
  5.  Click "Settings"
     
  6. Click " Change Pads Settings"
     
  7. From the drop down, Click "Daktronics OmniSport 2000
  8. Find the correct Port number for the USB plug. If you don't know what number port it is, unplug the cable to see what port number goes away, then plug the cable back in. The port number that reappears is the port. Click it"
  9. Click "Test Console"
  10. Select the number of pads you have plugged in."
  11. Click "Check response from OmniSport". The pads that are seen by the computer will turn Green. If all the pads you have plugged in turn green. Hit " Save "
     
  12. After you hit save close all the screens and go back to the first Meet Control Screen. Your Daktronics OmniSport is now ready. You do not need to make any changes to the computer or the console to run your events.

KB ID: DD2914161

DISCLAIMER: Use of this content may void the equipment warranty, please read the disclaimer prior to performing any service of the equipment.

DAKTRONICS DOES NOT PROMISE THAT THE CONTENT PROVIDED HEREIN IS ERROR-FREE OR THAT ANY DEFECTS WILL BE CORRECTED, OR THAT YOUR USE OF THE CONTENT WILL PROVIDE SPECIFIC RESULTS. THE CONTENT IS DELIVERED ON AN "AS-IS" AND "AS-AVAILABLE" BASIS. ALL INFORMATION PROVIDED IN THIS ARTICLE IS SUBJECT TO CHANGE WITHOUT NOTICE. DAKTRONICS DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ANY WARRANTIES OF ACCURACY, NON-INFRINGEMENT, MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. DAKTRONICS DISCLAIMS ANY AND ALL LIABILITY FOR THE ACTS, OMISSIONS AND CONDUCT OF YOU OR ANY THIRD PARTIES IN CONNECTION WITH OR RELATED TO YOUR USE OF THE CONTENT. ADJUSTMENT, REPAIR, OR SERVICE OF THE EQUIPMENT BY ANYONE OTHER THAN DAKTRONICS OR ITS AUTHORIZED REPAIR AGENTS MAY VOID THE EQUIPMENT WARRANTY. YOU ASSUME TOTAL RESPONSIBILITY FOR YOUR USE OF THE CONTENT AND ANY LINKED CONTENT. YOUR SOLE REMEDY AGAINST DAKTRONICS FOR DISSATISFACTION WITH THE CONTENT IS TO STOP USING THE CONTENT. THIS LIMITATION OF RELIEF IS A PART OF THE BARGAIN BETWEEN THE PARTIES.

The above disclaimer applies to any property damage, equipment failure, liability, infringement, or personal injury claim arising out of or in any way related to your use or application of the content, whether such claim is for breach of contract, tort, negligence or any other cause of action.