Digit and Price Displays: Unable to change one or more prices, Bad driver input
Potential Symptoms
- Red receive (rx) light remains light when disconnecting signal/communication input cable from driver.
- RX and TX (tx light on FL series drivers) lights could also just be blank.
- Unable to change prices on driver and any subsequent drivers in daisy chain.
- May have already swapped out communication equipment.
- Swapping out previous driver in daisy chain makes no difference.
- Display may show an E4 error message (no pricing info stored).
FL-3000 symptom
- Boot up for FLR3 connection may show AFF on failed driver.
- When in line mapping mode, some signs show prices while other show L01, L02, L03....
- Driver showing price is not entering line mapping mode.
Environment
- Product: DataMaster, FLR3-100/400, Fuelight, DF-2000, DF-2009, DF-2100, DF-2109, DF-2300, DF-4000, FL-2000, FL-2100, FL-2109, FL-2300, FL-3000, FL-4000, FL-4500 Gas Price or Petroleum Price Display, DF digit product, FL digit product
- Component: Digit Driver
- Control System:
Cause
- Bad signal input on driver.
Resolution
- Replace Driver.
- Make sure set the correct face and line address on the replacement driver (every driver in the display should have a unique line/face combination; e.g. 1L1, 1L2, 2L1, 2L2).
For Temporary Operation
- Move driver with bad signal input to the Host position. The Host driver does not utilize the line to line signal input.
KB ID: DD2481058
DISCLAIMER: Use of this content may void the equipment warranty, please read the disclaimer prior to performing any service of the equipment.
DAKTRONICS DOES NOT PROMISE THAT THE CONTENT PROVIDED HEREIN IS ERROR-FREE OR THAT ANY DEFECTS WILL BE CORRECTED, OR THAT YOUR USE OF THE CONTENT WILL PROVIDE SPECIFIC RESULTS. THE CONTENT IS DELIVERED ON AN "AS-IS" AND "AS-AVAILABLE" BASIS. ALL INFORMATION PROVIDED IN THIS ARTICLE IS SUBJECT TO CHANGE WITHOUT NOTICE. DAKTRONICS DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ANY WARRANTIES OF ACCURACY, NON-INFRINGEMENT, MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. DAKTRONICS DISCLAIMS ANY AND ALL LIABILITY FOR THE ACTS, OMISSIONS AND CONDUCT OF YOU OR ANY THIRD PARTIES IN CONNECTION WITH OR RELATED TO YOUR USE OF THE CONTENT. ADJUSTMENT, REPAIR, OR SERVICE OF THE EQUIPMENT BY ANYONE OTHER THAN DAKTRONICS OR ITS AUTHORIZED REPAIR AGENTS MAY VOID THE EQUIPMENT WARRANTY. YOU ASSUME TOTAL RESPONSIBILITY FOR YOUR USE OF THE CONTENT AND ANY LINKED CONTENT. YOUR SOLE REMEDY AGAINST DAKTRONICS FOR DISSATISFACTION WITH THE CONTENT IS TO STOP USING THE CONTENT. THIS LIMITATION OF RELIEF IS A PART OF THE BARGAIN BETWEEN THE PARTIES.
The above disclaimer applies to any property damage, equipment failure, liability, infringement, or personal injury claim arising out of or in any way related to your use or application of the content, whether such claim is for breach of contract, tort, negligence or any other cause of action.