Daktronics

How do I access the Web Interface of the Novastar H Series Processor?

Topic

How do I access the Web Interface of the Novastar H Series Processor?

Environment

  • Product: Novastar H Series Processor
  • Component: Novastar H2, H5, H9, H15, H20 Series Processor
  • Control System: Novastar

Steps

Prerequisites:

  1. You have completed the steps to connect a control PC to the device using one of the following methods:
    1. Connected a Control PC directly to the ethernet port on H Series processor.
    2. Connected a Control PC to a router or switch that the H Series processor is connected to.
  2. You have obtained the login user name and password.

Notes:

  • When an H series device is connected directly to a control PC, the device and control PC must be on the same network segment and their IP addresses cannot conflict. For example, if the device IP address is 192.168.0.10, the IP address of the control PC must be 192.168.0.X and X cannot be 10.
  • When an H series device is connected to a control PC using a router or switch, you must set to automatically get the IP address, and select Obtain an IP address automatically for the network settings on the control PC.
    1. Go to Settings > Communication from the home screen to enter the network settings screen.
    2. Click the IP Settings tab to enter the IP settings screen.
    3. Set the mode to Automatic.
    4. Click Main at the top left to return to the home screen and the current device IP address appears at the top right.
    5. Select Obtain an IP address automatically on the Internet protocol properties window on the control PC. The router or switch will assign the IP addresses to the device and control PC automatically. 

Procedure:

  1. Open a web browser on your computer, enter the device IP address in the address bar, and then press Enter to jump to the login interface for the Web page for the H series devices. 
  2. Enter the user name and password, and click Login to log in to the Web page.

KB ID: 000030006

DISCLAIMER: Use of this content may void the equipment warranty, please read the disclaimer prior to performing any service of the equipment.

DAKTRONICS DOES NOT PROMISE THAT THE CONTENT PROVIDED HEREIN IS ERROR-FREE OR THAT ANY DEFECTS WILL BE CORRECTED, OR THAT YOUR USE OF THE CONTENT WILL PROVIDE SPECIFIC RESULTS. THE CONTENT IS DELIVERED ON AN "AS-IS" AND "AS-AVAILABLE" BASIS. ALL INFORMATION PROVIDED IN THIS ARTICLE IS SUBJECT TO CHANGE WITHOUT NOTICE. DAKTRONICS DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ANY WARRANTIES OF ACCURACY, NON-INFRINGEMENT, MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. DAKTRONICS DISCLAIMS ANY AND ALL LIABILITY FOR THE ACTS, OMISSIONS AND CONDUCT OF YOU OR ANY THIRD PARTIES IN CONNECTION WITH OR RELATED TO YOUR USE OF THE CONTENT. ADJUSTMENT, REPAIR, OR SERVICE OF THE EQUIPMENT BY ANYONE OTHER THAN DAKTRONICS OR ITS AUTHORIZED REPAIR AGENTS MAY VOID THE EQUIPMENT WARRANTY. YOU ASSUME TOTAL RESPONSIBILITY FOR YOUR USE OF THE CONTENT AND ANY LINKED CONTENT. YOUR SOLE REMEDY AGAINST DAKTRONICS FOR DISSATISFACTION WITH THE CONTENT IS TO STOP USING THE CONTENT. THIS LIMITATION OF RELIEF IS A PART OF THE BARGAIN BETWEEN THE PARTIES.  

The above disclaimer applies to any property damage, equipment failure, liability, infringement, or personal injury claim arising out of or in any way related to your use or application of the content, whether such claim is for breach of contract, tort, negligence or any other cause of action.