Daktronics

How do I install a Gen V Radio Receiver, Gen VI Radio Receiver or a Base Station into an LED scoreboard?

Topic

  • Install a Gen V or VI Radio Receiver into an LED scoreboard.
  • Install a Base Station radio receiver into an LED scoreboard.

Environment

  • Product: Indoor / Outdoor Scoreboards
  • Components: Gen V radio receiver, Gen VI radio receiver, wireless base station
  • Control System: 

Steps

  1. Power the scoreboard down.
  2. Open the scoreboard in the area where the driver is and where the radio receiver will be.
  3. Feed the antenna cable through the antenna hole in the scoreboard and put on the washer and tighten the nut.
  4. Drill a 9/32" hole if needed.
  5. Attach the antenna with a washer outside and inside the scoreboard.
  6. Plug the radio power and signal cable into the radio connector coming off of the driver (J45) or the J21 connection on the driver.
    • If no J45 or J21 on board, plug receiver cable into J2 on signal radio surge card.
  7. Attach the radio receiver onto the inside wall of the scoreboard.
  8. For a Gen 5 or Gen 6 receiver follow Scoreboard: How do I change wireless scoreboard radio receiver settings? to set the desired broadcast and channel.
  9. For a Base station follow RC-100/RC-200:How do I change radio settings on the base station?  to set the desired broadcast and channel.
  10. Power on the scoreboard and look for POST and Broadcast and Channel settings.
  11. Power on the All Sport console.
  12. Press clear when asked to resume game.
  13. Input the correct code. Follow All Sport: What code should I use for my scoreboard?.
  14. Input the correct Broadcast and Channel settings that were displayed on the scoreboard.
  15. Verify that everything is operating correctly.

Additional Information

KB ID: 000009252

DISCLAIMER: Use of this content may void the equipment warranty, please read the disclaimer prior to performing any service of the equipment.

DAKTRONICS DOES NOT PROMISE THAT THE CONTENT PROVIDED HEREIN IS ERROR-FREE OR THAT ANY DEFECTS WILL BE CORRECTED, OR THAT YOUR USE OF THE CONTENT WILL PROVIDE SPECIFIC RESULTS. THE CONTENT IS DELIVERED ON AN "AS-IS" AND "AS-AVAILABLE" BASIS. ALL INFORMATION PROVIDED IN THIS ARTICLE IS SUBJECT TO CHANGE WITHOUT NOTICE. DAKTRONICS DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ANY WARRANTIES OF ACCURACY, NON-INFRINGEMENT, MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. DAKTRONICS DISCLAIMS ANY AND ALL LIABILITY FOR THE ACTS, OMISSIONS AND CONDUCT OF YOU OR ANY THIRD PARTIES IN CONNECTION WITH OR RELATED TO YOUR USE OF THE CONTENT. ADJUSTMENT, REPAIR, OR SERVICE OF THE EQUIPMENT BY ANYONE OTHER THAN DAKTRONICS OR ITS AUTHORIZED REPAIR AGENTS MAY VOID THE EQUIPMENT WARRANTY. YOU ASSUME TOTAL RESPONSIBILITY FOR YOUR USE OF THE CONTENT AND ANY LINKED CONTENT. YOUR SOLE REMEDY AGAINST DAKTRONICS FOR DISSATISFACTION WITH THE CONTENT IS TO STOP USING THE CONTENT. THIS LIMITATION OF RELIEF IS A PART OF THE BARGAIN BETWEEN THE PARTIES.

The above disclaimer applies to any property damage, equipment failure, liability, infringement, or personal injury claim arising out of or in any way related to your use or application of the content, whether such claim is for breach of contract, tort, negligence or any other cause of action.