Unable to connect to DMP after changing GS6 IP address; IP address set to DMP rather than VIP

Potential Symptoms

  • Unable to connect to DMP after setting a static IP address on GS6 display.
  • VIP may show online in Venus Control Suite (VCS) but DMP shows offline.
  • Not able to ping the DMP IP address from the VIP web configuration page. (From VIP version 2024.08.14-b2459 this feature is disabled.)
  • Unable to associate the DMP in VCS for newly installed display

Environment

  • Product: GS6, GT6X, GT6
  • Component: DMP-8000, DMP-8065, DMP-5050
  • Control System: Venus Control Suite

Cause

  • Static IP address was set on the DMP rather than the VIP.

Resolution

  1. Connect to the VIP web interface.
  2. Navigate to the "Configuration" tab and the "Network" subtab.
  3. Click the "Network Configuration Mode" drop down and select Ethernet-USB Bridge and send configuration (this will put the DMP directly on the network).
  4. Run software to detect the VIP/ DMP - display find, Wireshark, etc. (VIP and DMP should both show up as separate devices). If you are unable to find it, you may need to power cycle the display with this setting enabled.
  5. Log into DMP and configure IP settings for a NAT setup per How should a DMP be configured when using NAT on the VIP?
  6. Set the network configuration on the VIP back to NAT and set any desired display IP settings on the "eth0" portion of the VIP and then send configuration.

KB ID: DD3259120


DISCLAIMER: Use of this content may void the equipment warranty, please read the disclaimer prior to performing any service of the equipment.

DAKTRONICS DOES NOT PROMISE THAT THE CONTENT PROVIDED HEREIN IS ERROR-FREE OR THAT ANY DEFECTS WILL BE CORRECTED, OR THAT YOUR USE OF THE CONTENT WILL PROVIDE SPECIFIC RESULTS. THE CONTENT IS DELIVERED ON AN "AS-IS" AND "AS-AVAILABLE" BASIS. ALL INFORMATION PROVIDED IN THIS ARTICLE IS SUBJECT TO CHANGE WITHOUT NOTICE. DAKTRONICS DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ANY WARRANTIES OF ACCURACY, NON-INFRINGEMENT, MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. DAKTRONICS DISCLAIMS ANY AND ALL LIABILITY FOR THE ACTS, OMISSIONS AND CONDUCT OF YOU OR ANY THIRD PARTIES IN CONNECTION WITH OR RELATED TO YOUR USE OF THE CONTENT. ADJUSTMENT, REPAIR, OR SERVICE OF THE EQUIPMENT BY ANYONE OTHER THAN DAKTRONICS OR ITS AUTHORIZED REPAIR AGENTS MAY VOID THE EQUIPMENT WARRANTY. YOU ASSUME TOTAL RESPONSIBILITY FOR YOUR USE OF THE CONTENT AND ANY LINKED CONTENT. YOUR SOLE REMEDY AGAINST DAKTRONICS FOR DISSATISFACTION WITH THE CONTENT IS TO STOP USING THE CONTENT. THIS LIMITATION OF RELIEF IS A PART OF THE BARGAIN BETWEEN THE PARTIES.

The above disclaimer applies to any property damage, equipment failure, liability, infringement, or personal injury claim arising out of or in any way related to your use or application of the content, whether such claim is for breach of contract, tort, negligence or any other cause of action.