Scoreboard: How to set Time of Day on a Gyrus driver

Topic

  • How to program a Gyrus driver to show Time of Day(TOD) when signal is removed.

Environment

Steps

  • Note: If using address plug on Gyrus driver it must be removed before the following steps. It can be reinstalled once these steps are completed.
  1. Shut off power to the scoreboard at the breaker or unplug power cord for indoor models.
  2. Access the scoreboard driver to which the clock digits are connected.  Refer to the component location drawings for the scoreboard your working on to find the location of the driver.
  3. At the bottom of the driver are two address dials labeled "H" and "L".
    • Make a note of the position of both dials as they will need to be returned to their exact positions later.
  4. Use a small flathead screwdriver to move both H & L address dials to the "F" position.  This will set the scoreboard driver to diagnostics mode.
  5. Reapply power to the scoreboard.  If the driver has successfully entered Diagnostics Mode, the "Run" LED (DS2) will be blinking at a fast rate, about four times per second.
  6. Rotate the L address dial to the "0" position.  The "232" LED (DS1) will blink to show a change has been made:
    1. Three blinks = Time of Day Enabled
    2. Two blinks = Time of Day Disabled
  7. To exit Diagnostics Mode, rotate the High address dial (H) to any value other than "F".  This step MUST be performed to save the Time of Day setting!
  8. Set both address dials back to their original positions as noted in step 3.  Note that the "Run" LED (DS2) will now be blinking slower, about once per second, and the scoreboard will finish the power-up sequence to operate as normal.
  9. To revert or remove the TOD setting within the driver, repeat the same steps and watch for the two blinks to indicate you have disabled TOD.
  • All Sport console will need to be left on and connected for approximately 1 minute(If this does not work after 1 minute, leave it connected for several minutes) for the driver to gather enough packets to select the correct protocol and keep TOD on the scoreboard.
  • To adjust the current Time of Day settings, refer to the operation manual of the All Sport control console in use.

KB ID: DD3050027


DISCLAIMER: Use of this content may void the equipment warranty, please read the disclaimer prior to performing any service of the equipment.

DAKTRONICS DOES NOT PROMISE THAT THE CONTENT PROVIDED HEREIN IS ERROR-FREE OR THAT ANY DEFECTS WILL BE CORRECTED, OR THAT YOUR USE OF THE CONTENT WILL PROVIDE SPECIFIC RESULTS. THE CONTENT IS DELIVERED ON AN "AS-IS" AND "AS-AVAILABLE" BASIS. ALL INFORMATION PROVIDED IN THIS ARTICLE IS SUBJECT TO CHANGE WITHOUT NOTICE. DAKTRONICS DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ANY WARRANTIES OF ACCURACY, NON-INFRINGEMENT, MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. DAKTRONICS DISCLAIMS ANY AND ALL LIABILITY FOR THE ACTS, OMISSIONS AND CONDUCT OF YOU OR ANY THIRD PARTIES IN CONNECTION WITH OR RELATED TO YOUR USE OF THE CONTENT. ADJUSTMENT, REPAIR, OR SERVICE OF THE EQUIPMENT BY ANYONE OTHER THAN DAKTRONICS OR ITS AUTHORIZED REPAIR AGENTS MAY VOID THE EQUIPMENT WARRANTY. YOU ASSUME TOTAL RESPONSIBILITY FOR YOUR USE OF THE CONTENT AND ANY LINKED CONTENT. YOUR SOLE REMEDY AGAINST DAKTRONICS FOR DISSATISFACTION WITH THE CONTENT IS TO STOP USING THE CONTENT. THIS LIMITATION OF RELIEF IS A PART OF THE BARGAIN BETWEEN THE PARTIES.

The above disclaimer applies to any property damage, equipment failure, liability, infringement, or personal injury claim arising out of or in any way related to your use or application of the content, whether such claim is for breach of contract, tort, negligence or any other cause of action.