Daktronics

How to configure a new Lantronix device using Telnet

Topic

  • How to set up a new Lantronix device?
  • How to configure a Lantronix box?

Environment

  • Product Family: Message Displays
  • Product:
  • Component: Lantronix UDS-1100
  • Control System:

Steps

  1. Log in to the Lantronix device via Telnet using port (9999).
  2. In the telnet configuration page go to "Change Setup.
    1. Select #0 (Server Configuration).
      • Set or change the IP Address, subnet and gateway for the device.
        • Subnet will need Hosts bits, See note 2.
    2. Select #1 (Channel 1 Configuration).
      • Set or change the Baud Rate to 19200 for a Galaxy display.
      • Set I/F mode to 4C.
      • Flow Control will be none or [00] then press enter.
      • Connect mode should be [C0], if not adjust to C0, then press enter.
      • Set the Port to [03001] then enter. 
      • Remote IP Address [None]. 
      • Remote Port [00000].
      • Then the rest of the configuration just press ENTER until get to save the configuration.

      • Press [9] and then [Enter] to save and exit the setup mode.

Notes

  1. Net MaskHost Bits
    255.255.255.254Do not Use
    255.255.255.252Not recommended
    255.255.255.2483
    255.255.255.2404
    255.255.255.2245
    255.255.255.1926
    255.255.255.1287
    255.255.255.08
    255.255.254.09
    255.255.252.010
    255.255.248.011
    255.255.240.012
    255.255.224.013
    255.255.192.014
    255.255.128.015
    255.255.0.016
    255.254.0.017
    255.252.0.018
    255.248.0.019
    255.240.0.020
    255.224.0.021
    255.192.0.022
    255.128.0.023
    255.0.0.024

KB ID: DD2719106

DISCLAIMER: Use of this content may void the equipment warranty, please read the disclaimer prior to performing any service of the equipment.

DAKTRONICS DOES NOT PROMISE THAT THE CONTENT PROVIDED HEREIN IS ERROR-FREE OR THAT ANY DEFECTS WILL BE CORRECTED, OR THAT YOUR USE OF THE CONTENT WILL PROVIDE SPECIFIC RESULTS. THE CONTENT IS DELIVERED ON AN "AS-IS" AND "AS-AVAILABLE" BASIS. ALL INFORMATION PROVIDED IN THIS ARTICLE IS SUBJECT TO CHANGE WITHOUT NOTICE. DAKTRONICS DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ANY WARRANTIES OF ACCURACY, NON-INFRINGEMENT, MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. DAKTRONICS DISCLAIMS ANY AND ALL LIABILITY FOR THE ACTS, OMISSIONS AND CONDUCT OF YOU OR ANY THIRD PARTIES IN CONNECTION WITH OR RELATED TO YOUR USE OF THE CONTENT. ADJUSTMENT, REPAIR, OR SERVICE OF THE EQUIPMENT BY ANYONE OTHER THAN DAKTRONICS OR ITS AUTHORIZED REPAIR AGENTS MAY VOID THE EQUIPMENT WARRANTY. YOU ASSUME TOTAL RESPONSIBILITY FOR YOUR USE OF THE CONTENT AND ANY LINKED CONTENT. YOUR SOLE REMEDY AGAINST DAKTRONICS FOR DISSATISFACTION WITH THE CONTENT IS TO STOP USING THE CONTENT. THIS LIMITATION OF RELIEF IS A PART OF THE BARGAIN BETWEEN THE PARTIES.

The above disclaimer applies to any property damage, equipment failure, liability, infringement, or personal injury claim arising out of or in any way related to your use or application of the content, whether such claim is for breach of contract, tort, negligence or any other cause of action.