Daktronics

FL-3000/4500: How to Line map, using key fob, Gas Price Displays

Topic

  • How do I line map, address, or program an FL-3000/4500 series display with an FLR3-100/400 key fob?
  • How to address FL-3000/4500 Gas Price Displays with FLR3-100?

Environment

  • Product: Fuelight, FL-3000, FL-4500, Gas Price or Petroleum Price Display, FL digit product
  • Component: 
  • Control System: FLR3-100/FLR3-400 Key Fob (Wireless Communication Option), Handheld, Remote, Radio

Steps

Check out the setup video! --> https://www.youtube.com/watch?v=qAbSs1qaHw0.

  1. Press and hold the line 2 (+) and (-) buttons (at the same time) until the host display decimal flashes.  This will put the displays in line address mode.
  2. One display will slowly flash, press the (+) button on line 2 until the appropriate line number is shown.  (L01, L02, etc...)
    • Example: If you set a display to L02, then the key fob will change the price of that display by using Line 2 of the key fob.
  3. Once the line number is set, press and hold line 2 (+) and (-) buttons of the key fob for 3-4 seconds and then release them.  The next display face will begin to slowly flash.
  4. Repeat steps until all displays faces have been mapped.
  5. Exit this configuration mode by pressing and holding line 2 (+) and (-) buttons of the key fob until the displays show prices and are not flashing.  Should take about 7-10 seconds. 
    • Alternatively you can let the display timeout of Line Mapping mode by waiting about 5 minutes, this will provide time to verify all the displays are showing the correct line value and they don't accidentally get changed.
Refer to the Installation Quick Guides for more information. 

KB ID: 000013117

DISCLAIMER: Use of this content may void the equipment warranty, please read the disclaimer prior to performing any service of the equipment.

DAKTRONICS DOES NOT PROMISE THAT THE CONTENT PROVIDED HEREIN IS ERROR-FREE OR THAT ANY DEFECTS WILL BE CORRECTED, OR THAT YOUR USE OF THE CONTENT WILL PROVIDE SPECIFIC RESULTS. THE CONTENT IS DELIVERED ON AN "AS-IS" AND "AS-AVAILABLE" BASIS. ALL INFORMATION PROVIDED IN THIS ARTICLE IS SUBJECT TO CHANGE WITHOUT NOTICE. DAKTRONICS DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ANY WARRANTIES OF ACCURACY, NON-INFRINGEMENT, MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. DAKTRONICS DISCLAIMS ANY AND ALL LIABILITY FOR THE ACTS, OMISSIONS AND CONDUCT OF YOU OR ANY THIRD PARTIES IN CONNECTION WITH OR RELATED TO YOUR USE OF THE CONTENT. ADJUSTMENT, REPAIR, OR SERVICE OF THE EQUIPMENT BY ANYONE OTHER THAN DAKTRONICS OR ITS AUTHORIZED REPAIR AGENTS MAY VOID THE EQUIPMENT WARRANTY. YOU ASSUME TOTAL RESPONSIBILITY FOR YOUR USE OF THE CONTENT AND ANY LINKED CONTENT. YOUR SOLE REMEDY AGAINST DAKTRONICS FOR DISSATISFACTION WITH THE CONTENT IS TO STOP USING THE CONTENT. THIS LIMITATION OF RELIEF IS A PART OF THE BARGAIN BETWEEN THE PARTIES.

The above disclaimer applies to any property damage, equipment failure, liability, infringement, or personal injury claim arising out of or in any way related to your use or application of the content, whether such claim is for breach of contract, tort, negligence or any other cause of action.