How do I troubleshoot A-1778 Transition Networks converters?

Topic

  • How do I troubleshoot A-1778 Transition Networks converters?

Environment

  • Product: A-1778 fiber Ethernet media converters
  • Components:
  • Control System:

Steps

  • The A-1778 media converter has a single switch on it; LINK ALERT, and can be enabled or disabled.  Daktronics ships media converters with the switch set to the enabled state.
    0128191425a_HDR.jpg0128191425_HDR.jpg
  • When set to ENABLE the media converter does not act as an endpoint and an Ethernet link present on the device plugged into the converter indicates that the entire system is working and there is an Ethernet link present on the device on the other converter.
    • If there is a break in the system at any point between the devices plugged into the converters no Ethernet link will be present (ex. broken fiber, bad network cable, failed media converter, failed network jack).
  • When set to DISABLE the media converter does act as an endpoint and can be used to troubleshoot the system.  The expected results when set to disabled are as follows:
    • LINK ALERT disabled on building side media converter:
      • Plugging a laptop into the media converter will allow you to test the laptop's Ethernet jack, the Ethernet jack on the media converter, and the cable being used to connect them (regardless of the condition of the attached fiber, converter at the sign, or the sign itself).  Laptop plugged into the converter should show an Ethernet link.  
    • LINK ALERT enabled on building side media converter and disabled on the converter at the sign:
      • Laptop plugged into media converter at the building will show an Ethernet link if the following are true:
        • Laptop, Ethernet cable, building media converter, fiber being ran from TX on the sign converter to RX on building converter is working.
      • Laptop plugged into media converter at the building will not show an Ethernet link if one of the following is true:
        • Problem with the Ethernet portion of the connection from laptop to building media converter (testable via disabling switch above).
        • Problem with fiber running from TX on sign converter to RX on building converter.
          • Fiber can be flipped at both converters to test if one of the fibers is bad.
        • Problem with the fiber port on either converter.
          • Port can be tested by using a single fiber to loop across the ports on the converter.  When the switch is in the ENABLE state a laptop will show Ethernet link.
    • LINK ALERT disabled on sign media converter:
      • An Ethernet link on the controller (typically indicative by the sign booting up and showing an IP address) is indicative of the Ethernet port on the controller, the cabling between it and the media converter, and the Ethernet port on the media converter working (regardless of the condition of the attached fiber or building media converter).

KB ID: DD4111613


DISCLAIMER: Use of this content may void the equipment warranty, please read the disclaimer prior to performing any service of the equipment.

DAKTRONICS DOES NOT PROMISE THAT THE CONTENT PROVIDED HEREIN IS ERROR-FREE OR THAT ANY DEFECTS WILL BE CORRECTED, OR THAT YOUR USE OF THE CONTENT WILL PROVIDE SPECIFIC RESULTS. THE CONTENT IS DELIVERED ON AN "AS-IS" AND "AS-AVAILABLE" BASIS. ALL INFORMATION PROVIDED IN THIS ARTICLE IS SUBJECT TO CHANGE WITHOUT NOTICE. DAKTRONICS DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ANY WARRANTIES OF ACCURACY, NON-INFRINGEMENT, MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. DAKTRONICS DISCLAIMS ANY AND ALL LIABILITY FOR THE ACTS, OMISSIONS AND CONDUCT OF YOU OR ANY THIRD PARTIES IN CONNECTION WITH OR RELATED TO YOUR USE OF THE CONTENT. ADJUSTMENT, REPAIR, OR SERVICE OF THE EQUIPMENT BY ANYONE OTHER THAN DAKTRONICS OR ITS AUTHORIZED REPAIR AGENTS MAY VOID THE EQUIPMENT WARRANTY. YOU ASSUME TOTAL RESPONSIBILITY FOR YOUR USE OF THE CONTENT AND ANY LINKED CONTENT. YOUR SOLE REMEDY AGAINST DAKTRONICS FOR DISSATISFACTION WITH THE CONTENT IS TO STOP USING THE CONTENT. THIS LIMITATION OF RELIEF IS A PART OF THE BARGAIN BETWEEN THE PARTIES.

The above disclaimer applies to any property damage, equipment failure, liability, infringement, or personal injury claim arising out of or in any way related to your use or application of the content, whether such claim is for breach of contract, tort, negligence or any other cause of action.