Daktronics

How to setup RC-100 base stations in server client mode?

Potential Symptoms

  • Setup RC-100 base stations in server client mode for scoreboard or sporting applications.
  • Configure two delay of game (play) clocks to operate from one RC-100 handheld

Environment

  • Product Family: Sports Product, Digit and Price Displays
  • Product: Multiple Wireless Scoreboards, DOG (play) clocks, timers, Multiple wireless Price displays
  • Component: RC-100 Base Station (two or more) 
  • Control System:  Single RC-100 handheld controlling multiple boards simultaneously

Resolution

  1. Set all of the RC-100 Base Stations to the same Channel (usually channel 1) by changing S1 on the Base Stations.
    • Note: by default, the base stations are normally set to channel 1 when they are shipped out.
  2. For all newer RC-100 setups (handheld will show ED14905 v2.2 or higher on bootup), the Function dial (S2) should be set to 5.
  3. Wireless Base Station Server/Client Mode is selected via the "X1" Server/Client Jumper.
  4. Insert the jumper over the top two posts as shown in the "CLIENT" label on the circuit board to put one or more of the wireless Base Station in Client Mode.
  5. Insert the jumper over the top two posts as shown in the "SERVER" label on the circuit board to put one of the wireless Base Stations in Server Mode.
    • Note: by default, the base stations are normally set to server mode when they are shipped out.
  6. Set the RC-100 handheld controller to the same channel as the base stations.
  7. Verify everything is operating normally.
    1. To change the Sport Code being used on the RC-100 handheld:
      1. Press the ALT key in the bottom left.           
      2. Then press the NEW CODE button in the bottom right.
      3. Press ENTER/YES to select a new code.           
      4. Enter in the correct code from the number pad (correct codes can be found on inserts - e.g. code 05 for play clocks).
      5. Press ENTER/YES to confirm changes. 

KB ID: DD2342168

DISCLAIMER: Use of this content may void the equipment warranty, please read the disclaimer prior to performing any service of the equipment.

DAKTRONICS DOES NOT PROMISE THAT THE CONTENT PROVIDED HEREIN IS ERROR-FREE OR THAT ANY DEFECTS WILL BE CORRECTED, OR THAT YOUR USE OF THE CONTENT WILL PROVIDE SPECIFIC RESULTS. THE CONTENT IS DELIVERED ON AN "AS-IS" AND "AS-AVAILABLE" BASIS. ALL INFORMATION PROVIDED IN THIS ARTICLE IS SUBJECT TO CHANGE WITHOUT NOTICE. DAKTRONICS DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ANY WARRANTIES OF ACCURACY, NON-INFRINGEMENT, MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. DAKTRONICS DISCLAIMS ANY AND ALL LIABILITY FOR THE ACTS, OMISSIONS AND CONDUCT OF YOU OR ANY THIRD PARTIES IN CONNECTION WITH OR RELATED TO YOUR USE OF THE CONTENT. ADJUSTMENT, REPAIR, OR SERVICE OF THE EQUIPMENT BY ANYONE OTHER THAN DAKTRONICS OR ITS AUTHORIZED REPAIR AGENTS MAY VOID THE EQUIPMENT WARRANTY. YOU ASSUME TOTAL RESPONSIBILITY FOR YOUR USE OF THE CONTENT AND ANY LINKED CONTENT. YOUR SOLE REMEDY AGAINST DAKTRONICS FOR DISSATISFACTION WITH THE CONTENT IS TO STOP USING THE CONTENT. THIS LIMITATION OF RELIEF IS A PART OF THE BARGAIN BETWEEN THE PARTIES.

The above disclaimer applies to any property damage, equipment failure, liability, infringement, or personal injury claim arising out of or in any way related to your use or application of the content, whether such claim is for breach of contract, tort, negligence or any other cause of action.