How to disable or enable door switches on a VLink or VIP controller
Potential Symptoms
- Video Display playing grey.
- Not able to play 8000 content.
- Disable and enable a remote enclosure door switches.
Environment
- Product: Digital Billboard Displays
- Component: Remote Enclosure Door Switch
- Control System:
Resolution
VLink 1500/ValoPlay
Disabling a door switch
- Connect to controller using VLink 1500 Management Studio.
- Navigate to communications folder.
- Click on security.
- Uncheck the box next to "Enable door switch".
- Click the blue down arrow to set configuration.
- Door Switch Disabled
- Door Switch Disabled
Enabling a Door Switch
- Connect to VLink using VLink 1500 Management Studio.
- Navigate to communications folder.
- Click on security.
- Check the box next to "Enable door switch".
- Click the blue down arrow to set configuration.
- Door Switch Enabled
- Door Switch Enabled
Disabling a Door Switch
- Connect to VIP using UX web interface.
- Go to the Configuration heading and then the Peripherals tab.
- Highlight Door switch 1 and then click the red X to remove it.
- Click the page pointing to the right icon to set configuration.
Enabling a Door Switch
- Connect to VIP using UX web interface.
- Go to the Configuration heading and then the Peripherals tab.
- Click the green + sign and choose Door switch from the drop down.
- Once populated ensure that it uses address 1 and type is direct.
- Click the page pointing to the right icon to set configuration.
VIP-5060
Disabling a Door Switch
- Connect to VIP using UX web interface.
- Go to the Configuration heading and then the Peripherals tab.
- Highlight Door switch 2 and then click the red X to remove it.
- If Display is not a billboard, all door switches can be removed.
- Click the page pointing to the right icon to set configuration.
Enabling a Door Switch
- Connect to the VIP using the UX web interface.
- Go the Configuration heading and then Peripherals tab.
- Click the Green + sign and choose Door Switch from the drop down.
- Once populated ensure that is uses address 2.
- Click the page pointing to the right icon to set configuration.
KB ID: DD2024855
DISCLAIMER: Use of this content may void the equipment warranty, please read the disclaimer prior to performing any service of the equipment.
DAKTRONICS DOES NOT PROMISE THAT THE CONTENT PROVIDED HEREIN IS ERROR-FREE OR THAT ANY DEFECTS WILL BE CORRECTED, OR THAT YOUR USE OF THE CONTENT WILL PROVIDE SPECIFIC RESULTS. THE CONTENT IS DELIVERED ON AN "AS-IS" AND "AS-AVAILABLE" BASIS. ALL INFORMATION PROVIDED IN THIS ARTICLE IS SUBJECT TO CHANGE WITHOUT NOTICE. DAKTRONICS DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ANY WARRANTIES OF ACCURACY, NON-INFRINGEMENT, MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. DAKTRONICS DISCLAIMS ANY AND ALL LIABILITY FOR THE ACTS, OMISSIONS AND CONDUCT OF YOU OR ANY THIRD PARTIES IN CONNECTION WITH OR RELATED TO YOUR USE OF THE CONTENT. ADJUSTMENT, REPAIR, OR SERVICE OF THE EQUIPMENT BY ANYONE OTHER THAN DAKTRONICS OR ITS AUTHORIZED REPAIR AGENTS MAY VOID THE EQUIPMENT WARRANTY. YOU ASSUME TOTAL RESPONSIBILITY FOR YOUR USE OF THE CONTENT AND ANY LINKED CONTENT. YOUR SOLE REMEDY AGAINST DAKTRONICS FOR DISSATISFACTION WITH THE CONTENT IS TO STOP USING THE CONTENT. THIS LIMITATION OF RELIEF IS A PART OF THE BARGAIN BETWEEN THE PARTIES.
The above disclaimer applies to any property damage, equipment failure, liability, infringement, or personal injury claim arising out of or in any way related to your use or application of the content, whether such claim is for breach of contract, tort, negligence or any other cause of action.