How do I change the function of the scorer's table light strips?

​Question

  • How do I change when the scorer's table light strips come on?​

Environment

  • Product Family: Scoreboards and Timing 
  • Product: Scorers Table Light Strips
  • Component: ST-2302 w/ embedded light strips​
  • Control System:

Answer/Steps

  1. Open the rear access door on table 101 closest to the power inlet of the table. (right hand side if viewed from the rear)
  2. Locate the driver tray. There will be a terminal block with a single grey wire going into the bottom of it.
  3. Move this grey wire on the terminal block to the desired light strip function.
    • If light strips should come on at the end of period, place the wire in the terminal marked Clock = 0.
    • If light strips are desired on when the clock is stopped, place the wire in the terminal marked Clock = Stopped.
    • If the light strips should come on only when the horn sounds, place the wire in the terminal marked Horn.

 

KB ID: DD3763773


Fill out my online form.
DISCLAIMER: Use of this content may void the equipment warranty, please read this DISCLAIMER prior to performing any service of the equipment.