How do I change a MS-2013's communication from RC-100 wireless to AllSport 1610 hardwired.

Question

  • How do I change a MS-2013's communication from RC-100 wireless to All Sport 1610 hardwired.

Environment

  • MS-2013
  • RC-100
  • All Sport 1610

Instructions

  1. Open rear of scoreboard to access driver board and interface card.
  2. Locate the interface card, this is the smaller circuit board of the two.
  3. Locate J5 on the interface card and unplug it.
    1. Note: For models built prior to April 2015, the radio cable will connect to the 5-pin jack labeled “J45” coming from the LED driver.
  4. Close cabinet and utilize All Sport 1610 and the supplied 100ft 4pin XLR extension cable to connect to the scoreboard.

KB ID: DD2022978


Fill out my online form.
DISCLAIMER: Use of this content may void the equipment warranty, please read this DISCLAIMER prior to performing any service of the equipment.