Daktronics

Galaxy: How do I change the IP address settings on a message center?

Potential Symptoms

  • How do I change the IP address settings on a GP3, GP4, or GPC display?
  • How do I set a static IP address on a GP3, GP4, or GPC display?

Environment

  • Product Family: Message Displays
  • Product: GalaxyPro, GP3, GP4, GPC
  • Component: DMP-4060, DMP-8000, DMP-8065, DMP-8060, Daktronics Remote Display Configuration (DRDC)
  • Control System: GalaxyPro

Resolution

Step 1:  Access the configuration page for the display.

  1. Make sure Java and Silverlight are installed and updated.
  2. Open a web browser.
  3. Type the IP address of the display in the address bar.
  4. On the remote display configuration screen type the password for the display in the box.
    • GP3 "DMP-4060" will not have a password by default.
    • GP4 or GPC will have a default password that can be located in the display installation quick guide.
    • If a different password was set during the initial setup with Venus 1500 software use that password.
  5. Click on the Log In button to access the display configuration.

Step 2: Change the Network settings to the desired IP settings.

  1. Click on the Configuration tab and then select Network.
  2. Change the active port (default is Port 1) that is being used to the desired IP address, subnet mask, and default gateway.
  3. Click on the Send Configuration button on the left toolbar. (See screenshot below).
  4. Log out of the web interface by clicking on the red X on the left toolbar.
 
Refer to the Installation Quick Guides for more information. 

KB ID: DD1996041

DISCLAIMER: Use of this content may void the equipment warranty, please read the disclaimer prior to performing any service of the equipment.

DAKTRONICS DOES NOT PROMISE THAT THE CONTENT PROVIDED HEREIN IS ERROR-FREE OR THAT ANY DEFECTS WILL BE CORRECTED, OR THAT YOUR USE OF THE CONTENT WILL PROVIDE SPECIFIC RESULTS. THE CONTENT IS DELIVERED ON AN "AS-IS" AND "AS-AVAILABLE" BASIS. ALL INFORMATION PROVIDED IN THIS ARTICLE IS SUBJECT TO CHANGE WITHOUT NOTICE. DAKTRONICS DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ANY WARRANTIES OF ACCURACY, NON-INFRINGEMENT, MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. DAKTRONICS DISCLAIMS ANY AND ALL LIABILITY FOR THE ACTS, OMISSIONS AND CONDUCT OF YOU OR ANY THIRD PARTIES IN CONNECTION WITH OR RELATED TO YOUR USE OF THE CONTENT. ADJUSTMENT, REPAIR, OR SERVICE OF THE EQUIPMENT BY ANYONE OTHER THAN DAKTRONICS OR ITS AUTHORIZED REPAIR AGENTS MAY VOID THE EQUIPMENT WARRANTY. YOU ASSUME TOTAL RESPONSIBILITY FOR YOUR USE OF THE CONTENT AND ANY LINKED CONTENT. YOUR SOLE REMEDY AGAINST DAKTRONICS FOR DISSATISFACTION WITH THE CONTENT IS TO STOP USING THE CONTENT. THIS LIMITATION OF RELIEF IS A PART OF THE BARGAIN BETWEEN THE PARTIES.

The above disclaimer applies to any property damage, equipment failure, liability, infringement, or personal injury claim arising out of or in any way related to your use or application of the content, whether such claim is for breach of contract, tort, negligence or any other cause of action.