Daktronics

How to update firmware on a VFC-3000 controller using DFTP software

Potential Symptoms

  • How do you send a file using DFTP software?
  • How to update firmware using DFTP
  • How to update a VFC-3000 firmware

Environment

  • Product Family: Transportation
  • Product: Vanguard
  • Component: DFTP Software
  • Control System: VFC-3000, DDMS or M2/M3 controller types

Cause

  • Need to update the NTCIP version on the VFC-3000

Resolution

Note to download the firmware: How do I download VFC-3000 NTCIP firmware?
  1. Connect your computer to the controller's Ethernet port via an Ethernet cable.
  2. Set your IP to be within range of the controller's IP address.
  3. Open DFTP Software. DFTP Install
  4. Enter the controller's IP Address in the IP Address window.
  5. Click on the connect button. (DFTP software only communicates on port 161. You may need to change that on the controller temporarily.
    1. If necessary to change the controllers IP port:
    2. Go to the following controller menu's:
    3. Configuration
    4. Communication Configuration
    5. Ethernet Control Port
    6. IP Settings
    7. Controller IP Port.
    8. Note the controllers IP address, as you will need to know it later.
  6. Click on the file in the Local and Remote windows to highlight it.
    • When updating controller firmware, select the firmware file in the Remote window first, then the Local window so it is highlighted on both sides.
  7. Click on the >> button to copy it over to the remote target location.
  8. Click on Issue reset.
  9. Click on the Disconnect button and close DFTP.
  10. Log back into the controller and change the IP port to what it was set to before.

The following image is an example. Your file may be different than what is circled below.

DFTP.jpeg.jpg 

KB ID: DD2124626

DISCLAIMER: Use of this content may void the equipment warranty, please read the disclaimer prior to performing any service of the equipment.

DAKTRONICS DOES NOT PROMISE THAT THE CONTENT PROVIDED HEREIN IS ERROR-FREE OR THAT ANY DEFECTS WILL BE CORRECTED, OR THAT YOUR USE OF THE CONTENT WILL PROVIDE SPECIFIC RESULTS. THE CONTENT IS DELIVERED ON AN "AS-IS" AND "AS-AVAILABLE" BASIS. ALL INFORMATION PROVIDED IN THIS ARTICLE IS SUBJECT TO CHANGE WITHOUT NOTICE. DAKTRONICS DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ANY WARRANTIES OF ACCURACY, NON-INFRINGEMENT, MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. DAKTRONICS DISCLAIMS ANY AND ALL LIABILITY FOR THE ACTS, OMISSIONS AND CONDUCT OF YOU OR ANY THIRD PARTIES IN CONNECTION WITH OR RELATED TO YOUR USE OF THE CONTENT. ADJUSTMENT, REPAIR, OR SERVICE OF THE EQUIPMENT BY ANYONE OTHER THAN DAKTRONICS OR ITS AUTHORIZED REPAIR AGENTS MAY VOID THE EQUIPMENT WARRANTY. YOU ASSUME TOTAL RESPONSIBILITY FOR YOUR USE OF THE CONTENT AND ANY LINKED CONTENT. YOUR SOLE REMEDY AGAINST DAKTRONICS FOR DISSATISFACTION WITH THE CONTENT IS TO STOP USING THE CONTENT. THIS LIMITATION OF RELIEF IS A PART OF THE BARGAIN BETWEEN THE PARTIES.

The above disclaimer applies to any property damage, equipment failure, liability, infringement, or personal injury claim arising out of or in any way related to your use or application of the content, whether such claim is for breach of contract, tort, negligence or any other cause of action.